SwiftTool Carbon0.6 (black)

This is a 0.6 mm hardened steel nozzle that can be used with any filament but that is optimized for the use of abrasive filaments, like proCarbon or proGlass. These are strong carbon fiber and glass fiber reinforced nylon filaments suitable for heavy duty applications. Note that these materials only should be used with this kind of nozzle.

SwiftTool Multi0.4 (yellow)

This is the standard size brass nozzle, included with the optional Multi-Material kit. It is suitable for the softer filaments, like proPLA, proABS, proFlex, and proNylon. Note that this nozzle never should be used with proCarbon or proGlass.

SwiftTool Multi0.2 (red)

This is the high resolution nozzle included with the optional Multi-Material kit. It is suitable for the softer filaments, like proPLA, proABS, proFlex, and proNylon, to make smaller size models with high detail level. Note that this nozzle never should be used with proCarbon or proGlass.

This SwiftTool is 4-8 times slower than Multi0.4 when printing the same model.

SwiftTool Multi0.8 (green)

This is the low resolution nozzle included with the optional Multi-Material kit. It is suitable for the softer filaments, like proPLA, proABS, proFlex, and proNylon, to make larger size models with lower detail level. Note that this nozzle never should be used with proCarbon or proGlass.

This SwiftTool is 4-8 times quicker than Multi0.4 when printing the same model and may be used for quick draft prints.

Memory rule: Traffic light, Red=slow, Yellow=middle, Green=fast.